PAcket Tracer 7.1.5.2 Verify Non-Convergence Using Commands

In this lab all that needed to be done was to analyze the topology. some of the pings were not successful because of packets being sent the wrong way. This was seen using the show ip route in the routing table of R2 as instructed. There were two equal cost paths for the network 172.30.0/16. As a result, they are sent the wrong way. Another reason why pings from R1 fail is because of a network address that wasn't in R1 which was 172.30.100.0/24. After that i entered simulation mode to seethe where the packets go through. Following that i then went into the Event List filters in order to change the setting in order to se only the RIP events associated with the topology. What i was able to examine is that updates going to router R3 fail because of the network address that wasn't added to the routing table of R1.