Packet Tracer 7.1.2.3 Configuring Discontiguous Routes

In this packet tracer i was able to configure discontiguous routers using RIPv1. it was pretty straight forward. I went into all three routers and used router rip in order for configuring. For router R1 one thing that needed to be done was to combine to networks into one statement in order to enter it into rip. From there i used the passive-interface command in order to stop any updates from going to the networks that didn't have any routers. The same steps were done for the other two routers. After that all the needed to be done was to save the configurations so that it wouldn't be deleted if the entire topology were to be shutdown. To make sure all of my addresses were added i used the show ip route to see the rip configurations added to the routing table.