Lab 1.3.4.2 Dynamic Routing

in this lab it focused on static rouing. the difference between Static and Dynamic is that in static routing you would have to entering the addresses manually in the routing table through the CLI. In Dynamic routing is a change that happens automatically in the network topology as if it adapts. in this lab i went to the CLI in order to configure the the router by using a new command router RIP. after i configure RIP in router R2, R3, R4 i would then analyze the routing table on each of the routers. as i press R1 to show ip route i notice that router shows directly connected routes along with static and dynamic routes. from there i would move to ping from R3 to PC1 only for it to be successful. all in all i then configure a static route in R2 since a static route doesn't adapt to changes in the network like a dynamic route. fom ther i ping once again but instead with R3 to PC1 and reach 100% completion.