Tuesday, March 20, 2012

Packet Tracer 4.5.1.2 Routing Loops

In this lab i was able to troubleshoot a routing loop. it wasn't that difficult of an assignment because the only problem was that the interfaces were configured wrong. All that needed to be done was use no ip route 0.0.0.0 0.0.0.0 s0/1 because that was meant for router Branch 2. then i would use  ip route 0.0.0.0 0.0.0.0 s0/0 to branch 1. D=First i would have to enable an used the config command in order to do there configurations. As a result, i redid the ping that was asked of before and the ping was successful. the reason why was because it was there was no longer a loop on the packets since a proper configuration was added to the routing table.

No comments:

Post a Comment